Printer stops heating after 30 minutes

If you are using MK4DUO firmware and your printer stops printing after 30 minutes, you probably hit a 'feature' of the firmware. This is to protect you against leaving the machine heating while not printing. But it doesn't reset after move commands. Use the M530 command to explicitly start printing mode.

* M530 - Enables explicit printing mode (S1) or disables it (S0). L can set layer count

So in your start gcode of your slicer, put in M530 S1. In the end gcode M530 S0.


About ReprapWorld
ReprapWorld

ReprapWorld is the number one webshop for all your reprap supplies for your 3D printer. We have a large collection of 3D printer components, from our famous electronics lines to filament from our own production. And everything is at a very competitive price!

Contact

RepRapWorld B.V.
Wagenmaker 6a
2631RL Nootdorp
The Netherlands

Email: info@reprapworld.com
Tel: +31 (0) 85 - 009 15 31

Copyright 2009 - 2018 | RepRapWorld B.V.