We have added a large amount of new products. Our assortment of heated bed heating elements has doubled, adding 24V, 290mm and even a 40cm 240 silicon heater mat! In addition to this you may need to pickup up a solid state relay. Also we have added 20x20 slot covers in six colors.
For other (recently) added new product check out our new product section.
You can now add the ReprapWorld electronics boards directly into Arduino. Currently we support Megatronics, Ultratronics and the Anet A6 boards. You can find the instructions here.
Created by the RepRap-enthusiastic and experienced Gemstock3D team, this open-source extruder is a dependable addition to any FDM printer. Just add a Nema17 with sufficient power and you are ready to go!
Read more here
From now on we have a new section on the website for technical information. The goal is to have short question-answer type of documentation, with additional pictures. You can reach the section by navigating to customer service pages, but the information is also linked for relevant products from the documentation section on the product details page. We are going to fill op the section soon, if you have a question not answered here, please contact technical support (firstname.lastname@example.org).
We have upgraded the website again. A bit smaller update then last time, but with a few long asked functions available. We now accept USD and GBP in the .com an .co.uk shops respectively. Also we have introduced the (we think) very cool reprap.world domain for all international customers. .com is now recommended for USA customers only. When opening the .com site you will get a pop-up recommending your local shop (if available). If you have any problem with the website, don't hesitate to contact us an email@example.com.