Official Pololu 2A stepper driver for driving stepper motors in your 3D printer
This breakout board for Allegro’s A4988 microstepping bipolar stepper motor driver features adjustable current limiting, over-current and over-temperature protection, and five different microstep resolutions (down to 1/16-step). It operates from 8 V to 35 V and can deliver up to approximately 1 A per phase without a heat sink or forced air flow (it is rated for 2 A per coil with sufficient additional cooling). This board ships with 0.1″ male header pins included but not soldered in.
This product is a carrier board or breakout board for Allegro’s A4988 DMOS Microstepping Driver with Translator and Overcurrent Protection; we therefore recommend careful reading of the A4988 datasheet before using this product. This stepper motor driver lets you control one bipolar stepper motor at up to 2 A output current per coil (see the Power Dissipation Considerations section below for more information). Here are some of the driver’s key features:
|1 - 4:||excl € 6.16|
|5 - 9:||excl € 5.85|
|10 - 29:||excl € 5.70|
|30 - :||excl € 5.54|
|Need a larger quantity? Contact our Sales department.|
Related products that fit with the Pololu A4988 Stepper Motor Driver Carrier.